7/7/2023 0 Comments Motorcycle turn signal switchIt also has a threaded mirror mount as well as brake switch lever, headlight switch, and horn button. I just had to put a screw thru the external switch plate into the switch tab and it works fine again. I have one on CrazyBike2 from an old 80s Honda scooter, made of aluminum and well-worn and until I managed to drop Crazybike2's bars against a support pole for a roof, it survived just fine-even then, it only snapped the switch tab off, and was still intact and working inside. Trust me-they're WAAAAY better than any of the crap made for ebikes. If possible, get the controls unit off a motorcycle handlebar (or a replacement unit intended for one), preferably one made of metal rather than plastic. Oh, and I highly recommend using a turn signal switch you can easily move to any of the three positions but has a good center-off "catch", *and* that is smoothed for a thumb to just brush it whichever way is needed, while not really paying attention to it. You can buy blinkers for about any type of lighting you want, usually in the light bulb and fuses section of an auto parts store. I used thermal ones from cars and and an electromechanical one from a scooter for incandescents. I've built blinkers from various circuits found on the web or modified from existing ones and an electronic one from a scooter for LEDs. Some systems are setup the other way round, with the blinker at ground, and battery positive to the lights, but all the other interconnects would still be the same, in reverse polarity. left light's other wire to left side of turn signal switch
0 Comments
Leave a Reply. |